You have been redirected to your local version of the requested page

Polyurethane (PU) is a class of very important polymers due to its flexibility and insulating properties. It is used in various industries such as the automobile industry, in building construction, as well as in the production of synthetic fibers. PU is mostly produced via a chemical reaction between polyisocyanates and polyols. This results in linked networks forming «duroplasts», while the use of diisocyanates and dioles will lead to linear polymers, so-called «elastomers».

The isocyanate (NCO) content in the raw material is crucial to control its properties. If the isocyanate content of the raw material is unknown, a polyurethane with undesirable properties might be obtained. It is therefore quite important to determine the isocyanate content in these compounds. This Application Note shows an easy and straightforward way to determine the NCO content in polyurethane raw materials using a fully automated titration system from Metrohm.

The method is demonstrated on a polyurethane resin (PUR) and an unsaturated polyester resin (UPR). For both samples, no sample preparation is required.

Titrando system consisting of an 814 USB Sample Changer in combination with a 907 Titrando and tiamo.
Figure 1. Titrando system consisting of an 814 USB Sample Changer in combination with a 907 Titrando and tiamo.

The analyses are performed fully automatically using an 814 USB Sample Changer in combination with a 907 Titrando and a Solvotrode easyClean. The sample is weighed into a beaker, and toluene along with the reaction solution (consisting of dibutylamine in toluene) is added. After a reaction time of 15 minutes, acetone is added and the solution is titrated with hydrochloric acid until after the equivalence point is reached.

The blank is determined in the same way, but by omitting the sample.

Titration curve of the determination of the NCO value in polyurethane resin.
Figure 2. Titration curve of the determination of the NCO value in polyurethane resin.

Steep and smooth titration curves (see Figure 2) are obtained for all analyses. The automated analysis leads to reproducible results with a RSD < 2% as shown in Table 1.

Table 1. Results of the determination of the NCO content in polyurethane resin (PUR) and unsaturated polyester resin (UPR)
  n Mean value /% SD(abs)/ % SD(rel) /%
Polyurethane resin (PUR) 5 2.335 0.022 0.94
Unsaturated polyester resin (UPR) 5 0.826 0.016 1.94

The NCO content determination according to EN ISO 14896 is carried out without difficulties and can easily be automated. The waiting time of 15 minutes must be followed strictly, otherwise results might become falsified as the reaction time is elongated. Therefore, the automated addition of the auxiliary solutions is highly recommended.

Contact

Metrohm USA

9250 Camden Field Pkwy
33578 Riverview, FL

Contact

Internal reference: AW TI CH1-1228-102016