KF Titration – Titer determination 

It is difficult to make a general statement. The frequency of titer determination depends on a variety of different factors:

• leak-tightness of the titration system
• selection of the titrant
• humidity in the laboratory
• changes in room temperature
• requirements regarding exactness of the result

In principle, we recommend that titer determination should be carried out daily in the presence of high requirements concerning exactness. If no relevant changes are found, then the frequency can be reset to weekly. It should be noted that in general the titer of one-component reagents drops faster than that of two-component reagents.

	Sample size for 5 mL buret
Type of standard	Titrant 1	Titrant 2	Titrant 5
Water standard 10 mg/g	0.05–0.45 g	0.1–0.9 g	0.25–2.25 g
Na tartrate 156.6 mg/g		0.006–0.057 g	0.03–0.27 g
Water 1000 mg/g	–	–	~ 0.02 g
Water	–	–	~ 20 µL

 

	Sample size for 10 mL buret
Type of standard	Titrant 1	Titrant 2	Titrant 5
Water standard 10 mg/g	0.1–0.9 g	0.2–1.8 g	0.5–4.5 g
Na tartrate 156.6 mg/g	0.02–0.057 g	0.013–0.115 g	0.03–0.287 g
Water 1000 mg/g	–	~ 0.015 g	~ 0.025 g
Water	–	~ 15 µL	~ 25 µL

 

	Sample size for 20 mL buret
Type of standard	Titrant 1	Titrant 2	Titrant 5
Water standard 10 mg/g	0.2–1.8 g	0.4–3.6 g	1–9 g
Na tartrate 156.6 mg/g	0.02–0.175 g	0.026–0.23 g	0.065–0.58 g
Water 1000 mg/g	–	0.02–0.035 g	0.02–0.09 g
Water	–	15–35 µL	15–90 µL

The disodium tartrate dihydrate dissolves incompletely when several determinations are carried out in the same working medium because of the limited capacity of methanol to dissolve disodium tartrate dihydrate.

We recommend that you replace the working medium at shorter intervals.

The disodium tartrate dihydrate has probably not dissolved completely. The extraction time should be increased in order to prevent this.

In addition, care should be taken to ensure that the sample does not remain on the side of the vessel or on the electrode.

An increasing titer may be traced back to the limited capacity of the methanol to dissolve disodium tartrate dihydrate. We recommend that you replace the working medium at shorter intervals.

Another reason may be that the sample size selected was not optimal.

It is also possible to determine the titer with water. It should be noted in this connection that very small volumes have to be used. The handling takes a bit of getting used to in the beginning and requires a great deal of practice.

> The detailed procedural method can be seen in the videos here.